The voltage source is the same for the entire circuit so it will not be doubled.
In the case of automatic sensors if either are tripped the light stays on for the set time period. If both are tripped the light will stay on until both have time out.
Does sound simple, but what happens when one switch is on, which means the red wire of both are energized, then the other switch is turned on at the same time? Seems to me you have just doubled the volts on the wires leading to the light.
From: DoIt_Yourself@yahoogroups.com <DoIt_Yourself@yahoogroups.com> on behalf of ray dataman@daeo.net [DoIt_Yourself] <DoIt_Yourself@yahoogroups.com>
Sent: Sunday, April 2, 2017 6:58 PM
To: DoIt_Yourself@yahoogroups.com
Subject: Re: [DIY] For super-electricians.Yes! Did this on my bridge lights. I have sensors on each side so no mater witch direction you approach the bridge it lights up.
They are in essence just automated switches so you should be able to replace the switches with the sensors. The sensors have three wires as do the manual switches. Just wire them the same red to red, white to white and black to black.
Ray
On 4/2/2017 3:31 PM, Ron Johnson l0c0l0b0@hotmail.com [DoIt_Yourself] wrote:
We just started a managing another building. There are stairs that had a 3-way on top and bottom. The new owner says he wants a movement sensor in both places, instead. I am not familiar with a way that an arrangement like that can happen. Does anyone know of a way to do this?
Posted by: ray <dataman@daeo.net>
Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (5) |
No comments:
Post a Comment