Ok, this may sound a little strange but I'll toss it out there.
I have a 16 gal Shop Vac with an auto pump that pumps out the water via a garden hose as the vac starts to fill up.
I use it to help drain our hot tub and it works great. The only problem is, the suction is much faster than the pump
that pumps out the water so it fills up and shuts off before the pump can drain the vac.
What I do now is try and time it to so that I pull the suction hose out of the water before it completely fills up to allow
the pump to catch up. A major pain since I'm not always accurate.
What I'm thinking of doing is drilling a small hole into the side of the vac and putting a small plastic tube along the outside
to act as a water level indicator. But before I do that, I don't know if it'll work on a vacuum and I may compromise the
suction by doing so.
Anyone ever do this or know of any shop vac type of device that has this from the factory? I would think there's a valid
reason that manufacturers don't have this on wet/dry vacs although it sure would be handy. I searched on the web and
didn't see anything specific to doing this.
-aki
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (1) |
No comments:
Post a Comment