There is a little tool called a seat grinder. It removes deposits where the rubber seal touches. It is a not too expensive and not a power tool. Just a little is all you want. A few turns. No need to be pretty, just smooth. You could put a strip of fine grit sand paper over the end of a dowel and try it first.
--- In DoIt_Yourself@yahoogroups.com, "brian" <chanbr@...> wrote:
>
> In the past, when my bathroom shower leaked, if I replaced the seat and spring, I was able to fix the leaking. This time, after I replaced the seat and spring, it still leaks. What can I do now? I read somewhere that there might be some deposits in the house that's causing the problem. Can I sand the housing a little using a wet sand paper? Will that help? Any suggestions will be greatly appreciated.
>
>
>
> Thanks,
> Brian
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (2) |
No comments:
Post a Comment