Cartoon Network

12 April 2012

Re: [DIY] table saw smoking

 

Are you sure it has brushes?? Induction motors have a starting capacitor controlled by a centrifugal switch to give the motor a boost in starting. If that circuit doesn't cut out at speed, the motor will get hot/burn up. Ed

--- In DoIt_Yourself@yahoogroups.com, "Tom" <chtom@...> wrote:
>
> there were no jams. I think I need to replace the brushes. The space is tight where the hold on bolts are. any good sugestions as to how to remove them.
>
> --- In DoIt_Yourself@yahoogroups.com, "Tom" <chtom@> wrote:
> >
> > I'll check that. I appreciate the recommendation.
> > Tom
> >
> > --- In DoIt_Yourself@yahoogroups.com, JEFFREY WILLIAMS <livhosaere62@> wrote:
> > >
> > > take the little plate that's on top by the blade and look inside the blade guide.I have had a small chuck of wood get wedged in there causing it to smoke up running.
> > >
> > >
> > >
> > > ________________________________
> > > From: Dale S <dalu@>
> > > To: DoIt_Yourself@yahoogroups.com
> > > Sent: Monday, March 12, 2012 6:26 PM
> > > Subject: Re: [DIY] table saw smoking
> > >
> > >
> > >  
> > > It might be table saw time.
> > >
> > >
> > > Dale in the Flat Lands:----- I started out with nothing, and I still have most of it.
> > > Tom wrote:
> > > it wasn't smoking due to heavy ripping. I get the smoke even with no load.
> > > >
> > >
> >
>

__._,_.___
Recent Activity:
Please send decorating questions to Interior Motives List - to subscribe send an email to: Interior_Motives-subscribe@yahoogroups.com
.

__,_._,___

No comments:

Post a Comment