Do it Yourself: Re: [DIY] table saw smoking

13 April 2012

Re: [DIY] table saw smoking

According to the craftsman website on table saws, my model of saw has brushes

--- In DoIt_Yourself@yahoogroups.com, "Ed" <edmcm2000@...> wrote:
>
> Are you sure it has brushes?? Induction motors have a starting capacitor controlled by a centrifugal switch to give the motor a boost in starting. If that circuit doesn't cut out at speed, the motor will get hot/burn up. Ed
>
> --- In DoIt_Yourself@yahoogroups.com, "Tom" <chtom@> wrote:
> >
> > there were no jams. I think I need to replace the brushes. The space is tight where the hold on bolts are. any good sugestions as to how to remove them.
> >
> > --- In DoIt_Yourself@yahoogroups.com, "Tom" <chtom@> wrote:
> > >
> > > I'll check that. I appreciate the recommendation.
> > > Tom
> > >
> > > --- In DoIt_Yourself@yahoogroups.com, JEFFREY WILLIAMS <livhosaere62@> wrote:
> > > >
> > > > take the little plate that's on top by the blade and look inside the blade guide.I have had a small chuck of wood get wedged in there causing it to smoke up running.
> > > >
> > > >
> > > >
> > > > ________________________________
> > > > From: Dale S <dalu@>
> > > > To: DoIt_Yourself@yahoogroups.com
> > > > Sent: Monday, March 12, 2012 6:26 PM
> > > > Subject: Re: [DIY] table saw smoking
> > > >
> > > >
> > > > Â
> > > > It might be table saw time.
> > > >
> > > >
> > > > Dale in the Flat Lands:----- I started out with nothing, and I still have most of it.
> > > > Tom wrote:
> > > > it wasn't smoking due to heavy ripping. I get the smoke even with no load.
> > > > >
> > > >
> > >
> >
>