Yep, that sounds good to me…
From: DoIt_Yourself@yahoogroups.com [mailto:DoIt_Yourself@yahoogroups.com] On Behalf Of OOWONBS@Netscape.net
Sent: Saturday, June 02, 2012 4:40 PM
To: DoIt_Yourself@yahoogroups.com
Subject: Re: [DIY] Toilet flange is too high
Only in the back?!? You'll hate this...
Float the whole floor with leveler.
May as well add electric wires for warming the floor and a
nice tile. About 200 watts, but it's set on a thermostat
& a timer so on-time (~1hr?) is just for pre-breakfast
and as you desire.
BillSF9c
>I am putting a new toilet in the master bath and I have discovered that even with no wax seal, the toilet will not go flat to the floor. It sets about 1/4 inch high in the back. I am not crazy about removing the black cast iron flange.
>Can I install a spacer between the toilet and the floor? I can cut a piece of wood to exactly match the footprint of the toilet and glue it down before I install the toilet. But is wood the answer? Is there something better than wood? Thanks.
Google Jer Woodhaven
---------
No comments:
Post a Comment