And for don't forget, after cleaning, sharpen, then oil.
ck
From: DoIt_Yourself@yahoogroups.com [mailto:DoIt_Yourself@yahoogroups.com] On Behalf Of freespirt2050 gdb7edc
Sent: Friday, September 30, 2011 6:51 AM
To: DoIt_Yourself@yahoogroups.com
Subject: Re: [DIY] rusty tools
Depends on how bad the rust is, If its light blush, I take a paper towel and some WD 40 and polish the tool, if its deeper, some fine steel wool with some WD 40, If its very bad you could use some sand paper and then the paper towel and WD 40, Just depends on the tool and the use of it. For trowels I get em clean, for a shovel, not as concerned about the amount of fine cleaning...
From: ROSE <rjlt0407@yahoo.com>
To: DoIt_Yourself@yahoogroups.com
Sent: Friday, September 30, 2011 2:55 AM
Subject: [DIY] rusty tools
can someone tell me how you take the rust off older tools please thank you
No comments:
Post a Comment