We have the ethanol blends in Houston. I put some sea form additive in the tank every fill up and keeps it starting fine, and running smooth. Discovered the sea form while trying to start my outbourd motor which wasn't run for many years, couldn't get it to start. After some sea form added to the gas, and run thru the system, It started up and ran fine.
.
From: Terry Sullivan <terry12572@earthlink.net>
To: DoIt_Yourself@yahoogroups.com
Sent: Friday, September 20, 2013 10:08 AM
Subject: Re: [DIY] Lawn mower starting
To: DoIt_Yourself@yahoogroups.com
Sent: Friday, September 20, 2013 10:08 AM
Subject: Re: [DIY] Lawn mower starting
E-10 fuel is the only fuel available around here
(upstate New York). Even the higher octane fuels
have ethanol. I have used Sta-Bil in fresh gas
and installed a clean air filter, but that didn't
seem to help. The engine is only three years
old. But thanks to those of you who've said that
you've started your engines with starter fluid
for years without problems -- that's good to
hear. And I will try putting some liquid carburetor cleaner into the tank.
Terry
At 09:32 AM 9/20/2013, Dale wrote:
>
>
>I've started engines that way for years and have
>yet to blow one in the process. Are you
>perhaps using E-10 fuel, if so this might be a
>part of your problem. There really is not much
>to go wrong in those small engine carbs as most
>settings are pretty much fixed. I rather
>suspect that the engine is getting old and
>loosing some of its original compression so that
>it needs that little extra boost to start.
>
>Dale in the Flatlands. "Why waste time learning
>when ignorance is instantaneous."
><mailto:terry12572@earthlink.net>terry12572@earthlink.net wrote:
>>
>>>I have a walk-behind lawnmower that won't
>>>start unless I spray a little starting fluid in the air intake.
(upstate New York). Even the higher octane fuels
have ethanol. I have used Sta-Bil in fresh gas
and installed a clean air filter, but that didn't
seem to help. The engine is only three years
old. But thanks to those of you who've said that
you've started your engines with starter fluid
for years without problems -- that's good to
hear. And I will try putting some liquid carburetor cleaner into the tank.
Terry
At 09:32 AM 9/20/2013, Dale wrote:
>
>
>I've started engines that way for years and have
>yet to blow one in the process. Are you
>perhaps using E-10 fuel, if so this might be a
>part of your problem. There really is not much
>to go wrong in those small engine carbs as most
>settings are pretty much fixed. I rather
>suspect that the engine is getting old and
>loosing some of its original compression so that
>it needs that little extra boost to start.
>
>Dale in the Flatlands. "Why waste time learning
>when ignorance is instantaneous."
><mailto:terry12572@earthlink.net>terry12572@earthlink.net wrote:
>>
>>>I have a walk-behind lawnmower that won't
>>>start unless I spray a little starting fluid in the air intake.
__._,_.___
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (13) |
Please send decorating questions to Interior Motives List - to subscribe send an email to: Interior_Motives-subscribe@yahoogroups.com
.
__,_._,___
No comments:
Post a Comment