Mine is attached to wall of the crawl space which I never enter. Can this be done without access to other side or need a plumber.
--- In DoIt_Yourself@yahoogroups.com, "Bob Davis" <bob@...> wrote:
>
> It is very likely the anti-siphon thingy that is causing the leak. I had one
> that was leaking. I was unable to get it off, so ended replacing the whole
> hose bibb, which was probably a good idea anyway. It took five minutes to
> change out and nothing leaked after that. I threw the anti-siphon
> contraption in the garbage.
>
>
>
> Bob
>
>
>
> From: DoIt_Yourself@yahoogroups.com [mailto:DoIt_Yourself@yahoogroups.com]
> On Behalf Of Tori
> Sent: Wednesday, July 31, 2013 3:28 PM
> To: DoIt_Yourself@yahoogroups.com
> Subject: Re: [DIY] Hoses n spigots
>
>
>
>
>
> If i understand correctly, these washers come in several universal sizes and
> I just need to fit them into the hose end if its missing one? I did check
> one end the female(?) which attaches to the spigot- washer was there. The
> sprayer end (male?) does not need washer? Or do both ends always need
> washer?
>
> Also as far as the leak at the spigot- it is actually at the top where there
> is a plastic, very tight anti siphon cap on that and I can see there is a
> leak stemming from that spot. If anyone is familiar? It seems to create
> pressure there when I turn the water on so it leaks there as if IT needs a
> washer?
>
> --- In DoIt_Yourself@yahoogroups.com
> <mailto:DoIt_Yourself%40yahoogroups.com> , freespirt2050 gdb7edc
> <rich81850@> wrote:
> >
> > Also there should be a good rubber washer in the hose connection to the
> spigot, if it's bad or not in the hose connection, It will leak as well.
> >
> >
> >
> > ________________________________
> > From: subprong <subprong@>
> > To: DoIt_Yourself@yahoogroups.com <mailto:DoIt_Yourself%40yahoogroups.com>
>
> > Sent: Wednesday, July 24, 2013 2:40 PM
> > Subject: Re: [DIY] Hoses n spigots
> >
> > Â
> >
> >
> > If the leak is where the hose connects to the spigot (or hosebib) then you
> may want to just get some pipe tape and wrap it around the threads of the
> spigot and then screw the hose back on. I've had success doing that.Â
> >
> >
> > On Wed, Jul 24, 2013 at 10:55 AM, Tori <fertilegrnd@> wrote:
> > >Â
> > >>Very amateur lingo being used here. I have hoses and spigots whereas
> when i connect and turn on water there are leaks at the "connections". Is
> there a way to prevent this in future but also repair existing without
> plumbers or new hose?
> > >>
> > >>
> >
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (9) |
No comments:
Post a Comment