long story short:
I took the ugly light kit off my ceiling fan a few years ago, and the fan
worked fine.
I put new blades on it a couple of years ago (got 'em at a second-hand
store, and redrilled the holes)--fan worked fine (at least at slow and med.
speeds).
I put a new light kit on it last week. Lights work, fan doesn't.
I took the light kit back to the store, it was too bright anyway. Fan
still doesn't work.
There are no apparent loose wires in the bottom section of the fan where I
wired in the light. The factory wire joins are all sealed plastic tubes.
I assume there's more wiring in the next section up, where the blades
attach, but I haven't opened it up.
Any suggestions on looking for the problem?
thanks,
Lee
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (1) |
No comments:
Post a Comment