Do it Yourself: RE: [DIY] Wood Cut Sheet

01 January 2013

RE: [DIY] Wood Cut Sheet

Thanks to everyone for their suggestions. It will be very helpful.

From: DoIt_Yourself@yahoogroups.com [mailto:DoIt_Yourself@yahoogroups.com] On Behalf Of Dale S
Sent: Monday, December 31, 2012 7:29 PM
To: DoIt_Yourself@yahoogroups.com
Subject: Re: [DIY] Wood Cut Sheet

I use a CAD package called ALIBRE which was at one time available for a one time offer of $99.00 and since it normally cost about 400 I jumped. I don't know if it is still available for that price but if so I'd get it. I simply make 3D drawings of all the individual parts, then assemble them and when I'm satisfied with the final unit, lay out the individual parts on a diagram of my stock and get my best fit.

Now that I have impressed you with how I should do it, I'll tell the truth. I usually get my panels pre-cut in 2 foot by 4 foot panels for ease of handling and then what would otherwise be waste becomes shop drawers, tool chests and all the other smaller niceties I decide to make later on. Since most of my work is cabinets and the likes, 2x4 foot panels work out just right. The lumber yard has a good panel saw and so their cuts are easier to make than would be mine. I'm getting too old to wrestle 4x8 panels on a table saw or through the radial arm, and I'm too cheap to buy a panel saw of my own when I can use theirs for free. I do however make drawings first of all of my projects since it is so easy to get all of the dimensions and angles just right.

Dale in the Flatlands.

John S Moss wrote:

I’m looking for a better way to layout a cut sheet for a woodworking project. I have my materials list, but need to figure out what sizes wood I need to minimize waste. Drawing the layout by hand can get tedious and prone to arithmetic mistakes.

What do others use? I found a bunch of software online, but would like recommendations.

Thanks,
John

Death, like photography, is simply a series of chemical reactions.

--Franchesca Woodman