Dale,
I did try looking at Greenlee's page. The table of contents of their
punches had a lot of "no picture available", so I was guessing blind on
what to enter in the search to narrow it down.
Might be interesting to try fabricating my own punch, doing both
holes at once, but then I would be doing that for the interest
and learning curve about making dies/punches for a hydraulic
press (or if I ever get that fly press I want).
Add another interesting project to the wish list, take a number ;-)
dave
On 07/02/2012 08:15 PM, Dale S wrote:
>
>
> Greenlee makes all kinds of chassis and electrical punches.
> http://www.greenlee.com/
>
> Dale in the Flat Lands:-----
>
> Politics is supposed to be the second-oldest profession. I have come to realize that it bears a very close resemblance to the first.
> ~Ronald Reagan
>
>
>
>
> Dave Uebele wrote:
>>
>> Anyone know of a source for dies to punch holes in sheet metal
>> to allow installation 15-20 amp 120 volt outlets? (USA style plugs)
>>
>> I want to investigate the possibility of some power strips
>> to fit custom spaces.
>>
>> thanks
>> dave
>> --
>> Dave Uebele (daveu@sptddog.com <mailto:daveu%40sptddog.com>)
>>
>
>
>
>
--
Dave Uebele (daveu@sptddog.com)
No comments:
Post a Comment