A lot of hospitals have curved track curtains, to provide privacy in
multi-patient rooms, around beds.
Getting new hospital supply might be pricey, it might be possible
find old/salvage track, though if it includes a curtain,
I would clean/sterilize.
Easiest would be to bend electrical conduit, but then you need
to figure out how to support the rod, and still allow the curtain to
slide.
Really, 2 straight curtain rods coming out from the wall would be
easier. finding a system to is both supported and allows the curtain
to move around the bend is going to be more challenging.
I guess you could look into the track for garage doors, since it
does curve through 90. Would have to figure out reasonable loading,
since the weight would be 90 degrees off from normal loading of the
track.
Some of the modular wire frame closet rod systems might also
have a 90 degree turn.
dave
On 04/26/2013 01:25 PM, greatyoga wrote:
> We would like to make a space in a room about 60" by 60" in a corner. We were thinking of a curtain that makes a 90 degree bend (although it does not have to be a sharp bend). We are open to other ideas and if we do get a curtain like this, where could we get the curtain and rod and hopefully even make it inexpensively.
>
> Thank you,
> GB
--
Dave Uebele (daveu@sptddog.com)
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (3) |
No comments:
Post a Comment