contact paper cut a few inches wide and laid the width of
the sink over the rusted lip would last a week or few.
Ditto, spray enamel paint. Just tape the lip off from the rest.
Don't paint the whole thing. Newspaper to avoid overspray.
Condolences, of course.
If you have room, preferred nowadays is a divided sink, one
side being only large enough for a garbage disposal. Measure
the depth of what you have to avoid disappointment after a sale.
BillSF9c
Powdercoat cast iron sink? Posted by: "Cecile" clme849@yahoo.com clme849 Thanks, everyone for your replies, I may just get the new one. My sister would not even consider anything but cast iron. Our Mama just died unexpectedly last Sunday so this will have to wait.
> > I live with my sister and the kitchen sink is rusting, mostly on the top > edge. I asked at one place about having it powder coated and he said if it > would fit in 7 x7 area he could do it for around $50. It weighs a lot, but I > think we could get it out. Does anyone have any experience with this > coating? Does it look nice? Does it last? Special care? Etc. > >
No comments:
Post a Comment