Cartoon Network

25 May 2014

RE: [DIY] Dishwasher Wire

 

DEFINATELY!  I had a dishwasher that was hardwired once.  I had to add a new receptacle and install a pig-tail so there is a disconnect in case there is any need to work on it. 
 
The same guy who installed it in also laid the waist line from the dishwasher on the bottom of the cabinet.  It should be higher than the bottom of the sink; otherwise if there is a sink back-up, you get waste water in the dishwasher.
 
Personally, unless you need a dishwasher (ie have lots of children) I don't recommend one.  Too many things to go wrong.
 

To: DoIt_Yourself@yahoogroups.com
From: DoIt_Yourself@yahoogroups.com
Date: Sun, 25 May 2014 03:33:52 -0700
Subject: Re: [DIY] Dishwasher Wire

 
NEC requires a 20-ampere circuit for the dishwasher, so a 12/2 with ground is required. you will also need a local disconnect; generally, a duplex receptacle is placed in the space under the sink to serve the dishwasher and disposal unit.the disposal is usually on a switch adjacent to the sink with the power wire to the dishwasher circuit going to the switch first, then a piece of 12/3 with ground going to the receptacle. at the receptacle, the small piece of metal between the screws on the hot side of the receptacle twisted off to separate the two receptacles, allowing the switch to operate the disposal and the dishwasher side to remain energized continuously.


On Sunday, May 25, 2014 12:20 AM, "Jerry Hnidy jhnidy@gmail.com [DoIt_Yourself]" <DoIt_Yourself@yahoogroups.com> wrote:


 
Can i use ,14\3 or do i have to run mew



__._,_.___

Posted by: Ron Johnson <l0c0l0b0@hotmail.com>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (3)
Please send decorating questions to Interior Motives List - to subscribe send an email to: Interior_Motives-subscribe@yahoogroups.com

.

__,_._,___

No comments:

Post a Comment