Cartoon Network

16 January 2016

[DIY] Re: Water softener discharge

 

I also thought of contamination if the back flow valve did not kick in in time. The softener does back wash under 50-60 pound pressure from the well tank. I've also been looking for a valve that would install near the softeners tank and drain off leftover water in the line after the the back flow valve and softeners backwash cycle ends. I was thinking in that way no contaminated, if any, water would touch the backwash water. I can't seem to locate that type of valve. I Googled unloader valve but that's for pressure washers.

I could run a line to my laundry sink upstairs about 40 ft away and let it drain into that. That would be an easy air gap. Problem there is family members soak clothes in there and that spells disaster if the softener starts to run.

I check around to see what others around here do and also check with septic and plumbers. I've heard the term air gap for dishwashers so I'll also see how they operate.

Thanks to everyone for the input.
Gene



---In DoIt_Yourself@yahoogroups.com, <THenne1713@...> wrote :

I have the same concerns as Mike, and also think that a pressure connection/ gravity drain to a drain without an air gap is a code violation and probably not smart.  My daughter's family just went through issues with an outdoor gas pack condensate drain connected to septic (Guessing without an air gap?) backed up into the condensate pan after the septic filled during rainy season.  This resulted in nasty odors and heat shutdown for several days until they could get servicemen out to clean the A/c drain system and pump the septic.

My concern for you would be more that after a drain clog, it would contaminate the water softener/ potable water and KILL YOU (and others?)...


(Mike said) <<
might want to check with a septic tank company-will the discharge from your water softener mess up your septic tank? is the discharge pressurized? if so, you may want to connect to the drain line thru an upward facing "Y" fitting so that the fall of the waste water will be forced down: that is, one side of the Y connects to the existing drain and your water softener drain would connect to the other side of the Y. when connecting a condensate drain (from and air conditioning coil for example) I am required to leave an air gap at my connection to avoid any back-up into my drain line;any back-up from the out going drain would spill out thru the air gap I suppose>>

Terry
thenne1713@...

__._,_.___

Posted by: multiuseguy@yahoo.com
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (5)
Please send decorating questions to Interior Motives List - to subscribe send an email to: Interior_Motives-subscribe@yahoogroups.com

.

__,_._,___

No comments:

Post a Comment