I can aki but it comes from the wall, there is a T connection and one goes up to faucet the other to DW, there is nothing else connected there. The only other thing I can think of is they installed the instant hot at the same time, but it just hooks up and plugs in. I don't think it could have crossed with the hot water line - it always works, water are 160 whenever you turn it on. I can take a picture anyway. Maybe someone else can see something.
I am baffled about this, too. Does the line to the DW run inside the cabinet from sink to DW? The water in that line (probably 1/4" copper or flex) is going to be @ room temp., not 50 degrees. There is no connection of the cold water line to the DW.
On a job of mine today (I am not the plumber), they capped off the water lines to the sink and DW, then all other faucets were running hot to both cold and hot faucets. Sure made me think of this thread.
P.S.: I hate that computer keyboards do not have a degree symbol key.Terry, this formula sounds correct and if this is the problem, I don't see any way to ever get hot water into the DW in time to dissolve the detergent (and get clean dishes) - short of running a light cycle first, 50 minutes with no dry, or running the heavy soil cycle, almost 2 hours and wasting lots of water. If I use the heat water choice, it adds another hours to the cycle and no idea how much energy to heat the water. So much for paying extra for an energy saving device :) GE recommends and I prefer to use, the packets. No big bottle of liquid to store, no drips, no measuring.
Our cold water is about 50 degrees, faucet at least 130 — so that probably accounts for the first fill at 80 degrees — but I still have a hard time believing there is over a gal of cold water in the line. It is at most 3.5- 4', laid out. Extends from the connection on the right side of cabinet, across the back and comes up under the DW and connects near the left side. If I unhooked this line and filled it with water I don't think it would hold 16oz.On Jan 5, 2016, at 10:26 PM, Terry THenne1713@aol.com [DoIt_Yourself] <DoIt_Yourself@yahoogroups.com> wrote:Water and Air Temps are Proportional, e.g. 1-gallon 100'f water mixed with 1-gal 50'f water will give =75-deg water;
(another) I-gal. @140-deg + 1/2-gal @40-deg= 106-deg (if my math is right)
Note the 40-deg= 33% of 1-1/2-gal total volume (so math is (66%x 140-deg)+(33%x40-deg) = 92.4+ 13.2= 105.6-degreesMaybe you are onto something there...???
The winter changes, I believe, are why DW have heaters to reheat the water if too cold, before starting cycle. (recalling my old Maytag), you can turn it OFF w/ control switch/ button in summer, or if using soap that works w/ cold
Attachment(s) from oakridgefarm@gmail.com | View attachments on the web
1 of 1 File(s)
Posted by: "oakridgefarm@gmail.com" <oakridgefarm@gmail.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (5) |
No comments:
Post a Comment