Set the towel rod on the table, start the two screws in the holes, just a
thread or two then put the rod back on the wall and tighten the screws
ck
-----Original Message-----
From: DoIt_Yourself@yahoogroups.com [mailto:DoIt_Yourself@yahoogroups.com]
On Behalf Of Carol Botteron
Sent: Tuesday, January 24, 2012 5:18 PM
To: DoIt_Yourself@yahoogroups.com
Subject: [DIY] Headless Set Screws
I took down a towel rod and attached the brackets better to the wall.
To put the whole thing back together I have to re-insert two tiny headless
set screws into the undersides of the mounting arms. Each screw has a slot
in one end for a screwdriver, something like this:
http://www.seekpart.com/company/47203/products/20119891618865625.html
The screws are too short to hold with my fingers while I start to screw them
in. Needle nose pliers don't grip the screws very well.
If I lose my grip the screw will probably vanish forever.
How can I either hold the screw or attach it temporarily to the screwdriver?
Have seen screwdrivers that are magnetic and others that have little
grippers for screws, but I don't have these.
adTHANKSvance!
------------------------------------
Please send decorating questions to Interior Motives List - to subscribe
send an email to: Interior_Motives-subscribe@yahoogroups.com Yahoo! Groups
Links
No comments:
Post a Comment