Thanks everyone. I was able to replace the hosebib. It came off easier than I had anticipated. I ended up getting a couple of 10" plumbers wrenches. I used them both (one holding the T-adapter in place and the other to loosen the hosebib) for removal. However I had to use an adjustable wrench to insert the new hosebib as the jaw on the plumbers wrench was too wide to get to the hex area on the new hosebib.
A question. After removing the old hosebib, I was drying out the area in the T adapter female threaded area before installing the new hosebib. I felt something in there and saw that there is a chunk of rust that has grown inside the T adapter just before the threads start on the inside. I pushed and pulled slightly on the rust and noticed that it was firm. I did not want to try to chip it out and am not even sure if that would have been possible. I took photos of the rust chunk on the inside... if you need to see it, I'll upload it. This is the same T adapter that is rusted on the outside.
1. Is this rust on the interior common?
2. Outside of replacing the adapter what can be done if anything is needed to be done?
2. Do 1/4 turn valves spray out water instead of a steady flow or is this spraying/showering out water because that chunk of rust is causing some blockage?
4. Is the water safe to consume?
Thanks.
The 1/4 turn handle on my outdoor hosebib started to deteriorate a few months ago. The framed ring on the underneath the knob was falling apart and therefore was not properly seated around the turn nipple (sorry I don't have a better term) that sticks up into it. So it needed to be turned past its usual points to go completely on or off. Recently the water hadn't been turning on at full power.
I removed the handle/knob and screw and decided to turn the nipple with a wrench. I was able to turn it on and off a couple of times. Then as I'm trying to turn it off again it's taking at least 5 full revolutions until it finally shuts the water off. After this I try to turn it back on. After several turns it does not turn on again
Is this something that can be fixed without replacing the entire hosebib/spigot? I assumed the nipple and waterflow turn piece below it would be 1 single piece and therefore shouldn't have any mechanisms below it to cause this. I guess I'm wrong or I'm doing something wrong.
If the entire thing must be replaced, do you have any advice on a replacement hosebib and a type of pipe wrench(es) to get and what to look out for when taking it off and installing the new one? I see that there are anti-syphoning varieties. I don't think I'll need the frost-free types. I do like the idea of some of the spigot mouths sitting at a 45 degree angle (kink-free).
I have some boiler spigots. Can these be used outdoors?
Just a note. I actually tried to find the same type of knob/handle at the box stores awhile back hoping that I could buy the entire hosebib and take off the handle of the new one and place that on my existing one. However, I could not find the same variety. Also, the nipples on my boiler spigots are squarish where as the one on my exterior hosebib is more rectangle with roundish edges.
Thanks.
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (1) |
No comments:
Post a Comment