Yes, but they are not cheap by any means, but if you need them and many of them, then not as bad.
Rich B
On 8/19/2011 2:18 PM, S_Wilson wrote:
You beat me too it. We probably sent these emails at about the same time but I used the wrong email address to send it from and it returned to me.
This is what I wrote:
A thought I had was to look for stainless staples. I did a search online and found some but staples come in many widths, sizes and gauges. You'd have to find what you think might work. You wouldn't have the problem of a coating on them with stainless.
Steve
On 8/19/2011 12:04 PM, Rich B wrote:You can buy Stainless, http://www.stapleheadquarters.com/heavy-stainless-staples.html
Rich B
On 8/19/2011 12:33 PM, subprong wrote:Thanks for your response, freespirt2050. That touch up coating sounds interesting.
Any advice on other fasteners? Attaching welded wire (kind of like chicken wire) to wood. My only other thought is that they probably make hot dipped galvanized fence staples that you manually hammer. Pneumatic stapling would be so much quicker though.
On Fri, Aug 19, 2011 at 5:47 AM, freespirt2050 gdb7edc <rich81850@yahoo.com> wrote:
I would think the Electro plated may be, because of the plating process, but the dipping may leave a heavier coating, If it is scraped of, Obviously the metal will be less protected, but the sell a producd whic is cold galvanize which is in a spray can, for touch up. Tehy do make other types of outdoor fasteners you could look into, just depends on what your fastening.
--- On Fri, 8/19/11, subprong <subprong@gmail.com> wrote:
> From: subprong <subprong@gmail.com>
> Subject: Re: [DIY] Compressor Staples
> To: DoIt_Yourself@yahoogroups.com
> Date: Friday, August 19, 2011, 2:13 AM
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> Yes, um, thanks.
>
> Does anyone know which type of galvanization will last
> longer outdoors. "Electro plated galvanization"
> or "hot galvanization". Not "hot
> dipped" (the best). Simply "hot
> galvanization".
>
>
> I've read the two different processes. I've also
> read that zinc on electro plated starts to immediately break
> down in exterior elements. I have not seen whether
> "hot galvanization" is either better or worse.
>
>
> On Thu, Aug 18, 2011
> at 9:25 PM, Dale S <dalu@hbcomm.net>
> wrote:
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> Rust
>
> Dale in the Flat Lands
>
>
>
> subprong wrote:
> What should I expect if I use these
> outdoors?
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
No comments:
Post a Comment